User and safety guide

Follow these instructions to keep using the hot tub enjoyable and safe for both people and property.

Setting up

  1. Choose a level and firm surface.
  2. Place the hot tub at least 4 metres away from buildings.
  3. Use wheel chocks on the trailer before unhitching it from the car.
  4. Place support blocks under the support legs.
  5. Make sure the hot tub is level with the ground.
  6. Lift the jockey wheel off the ground so it does not break under the weight of the water.
  7. Install the chimney on the stove. We recommend wearing protective gloves, as chimney parts can be very sharp.
  8. Fill the hot tub with water – the water level must be at least 10 cm above the stove’s upper pipe opening.

Heating

  1. You can start heating once the water level is at least 10 cm above the stove’s upper pipe opening.
  2. Heat the stove with dry firewood; do not use charcoal.
  3. Never leave the stove unattended while heating. During and after heating, the chimney and stove are hot and can cause burns on contact.
  4. Do not use paper to light the wood – it can produce excessive flying sparks or ash.
  5. Depending on the weather, heat the water to about 35–38 °C, but no higher than +41 °C. Water above body temperature is hard to stay in for long and can cause health problems over extended periods.
  6. In sub-zero temperatures, do not let the water freeze in the stove. Never light a fire in a frozen stove!

Using the hot tub

  1. The bubble system requires connecting the power cable. The cable is on the left side of the trailer, under the tub.
  2. Take a shower before using the hot tub.
  3. Never jump into the hot tub!
  4. Never leave children or people who have consumed alcohol unsupervised in the hot tub.
  5. Wet surfaces can be slippery. Risk of injury!

After use

  1. Never transport the hot tub filled with water!
  2. Only drain the water once the embers in the stove are completely extinguished!
  3. In winter, always drain the hot tub after use. Freezing water can break the hot tub and the stove! Leave the drain valve open as well, so the valve does not freeze and burst!
  4. Put the cover on the hot tub for transport.
  5. The cover must be fastened correctly. The fastening points must line up with the holes in the cover – pull the bungee cord down between two holes and over the fastening point.
  6. Do not use detergents or other cleaning agents. We do the thorough cleaning ourselves, but if you like, rinse off larger debris with clean water.